Operation process of radial drilling machine

Operation process of radial drilling machine
1. Carry out a comprehensive inspection on the amount of drilling machine and work card used before work, and work after confirming that there is no error.
2. It is strictly prohibited to wear gloves, and the girl's hair braid should be tied in the hat.
3. Workpiece clamping must be firm and reliable. When drilling small parts, it shall be clamped by tools, and it is not allowed to hold the drill by hand.
4. Select the feed speed and adjust the travel limit block when using the automatic tool feed. During manual feed, it is generally carried out in accordance with the principle of gradual pressure increase and gradual pressure decrease, so as to avoid accidents caused by excessive use.
5. When adjusting the speed, stroke, clamping tools and workpieces of the drilling machine, and when wiping the machine, stop the machine.
6. When there are long iron chips on the drill bit, stop the machine to remove them. It is forbidden to blow with wind or pull by hand. It should be removed with brush or iron hook.
7. When finishing reaming deep holes, pull out the rounder and pin bar. Do not use too much force to avoid hitting the tool with your hand.
8. It is not allowed to turn, press or measure the workpiece under the rotating tool. Do not touch the rotating tool.
9. When using the radial drill, there shall be no obstacles within the slewing range of the cross arm. Before working, the cross arm must be clamped tightly.
10. It is not allowed to store objects on the cross arm and workbench, and the processed parts must be clamped according to the regulations, so as to prevent serious personal injury accidents and equipment accidents caused by workpiece displacement.
11. at the end of the work, lower the cross arm to the lowest position, and the headstock is close to the column and should be clamped tightly.
The radial drilling machine produced by Zaozhuang Make Machinery Co., Ltd. is of high quality and well received by customers.